OPERATION
Power on/off
• To turn the headphones on, press and hold the Power button (9) until the Status LED
(3) blinks BLUE and RED.
• To turn the headphones off, press and hold the Power button again until the Status
LED blinks RED.
ANC on/off
• To turn noise cancellation on, short press the ANC switch (2). The LED indicator (3) will
light up GREEN.
• To turn noise cancellation off, short press the ANC switch. The ANC LED will turn off.
Charging
1. Connect the USB-C charging cable to the charging port (4) on the headphones.
2. Connect the other end of the cable to a USB power adapter or a computer.
3. The LED will turn RED during charging and turn off when the battery is fully
charged. The LED will flash RED if the battery level is low.
WARNING: Do not use the headphones whilst they are charging.
Bluetooth pairing
1. Make sure the headphones are turned off.
2. Press and hold the Power button (9) for 5 seconds to enter pairing mode. The
Status LED (3) will flash BLUE and RED.
3. Turn on Bluetooth on your device and search for “Kogan NC35 Headphones”,
select it when found.
Note: Some devices may ask to confirm the headset connection after pairing.
4. If pairing is successful, the status LED will blink BLUE. If no Bluetooth devices are
paired within 3 minutes the headphones will turn off.
Loading...
