360x90mm
PAIR YOUR
DEVICE
Controls
Setꢀup your
N86
PAIRING MODE
Activate audio device and search for the
“N86”, select it to connect.
Turn on N86. Indicator Light will ash blue
and red, indicating the N86 is ready to pair.
N86 will announce, “Connected”, and the
Indicator Light will turn ash blue. Your device
is now successfully paired!
Previous Track/Volume Down
Mic
Next Track/Volume Up
Power/Play/Pause
Answer Call
LED Indicator Light
If you are prompted to enter a password,
use “0000”.
Wireless
TURNING ON/OFF
Long press “
”.
READY TO PLAY!
Aux In
1 N86
If you don't connect a device within 30 seconds, the
N86 will enter sleep mode.
Turn the N86 off and then on again to re-enter pairing mode.
ANC function On/OFF
Type-C recharging port
1 USB Type-C charging Cable
1 3.5mm Aux cable
1 User manual
1 Carry Bag
If the N86 is moved out of range, bring your device closer and start over to pair again.
N86
USER GUIDE
FCC WARNING below:
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are
ANC ON/OFF
HANDS-FREE
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
Switch on the ANC button, you will start to enjoy a quiet world.
If you want to close the ANC function, just switch off ANC button.
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
FAIL TO PAIR
When a phone call is in coming, press the“
”button to answer with the N86.
Make sure the N86 is in pairing mode and the Indicator Light is ashing blue and red.
To re-enter pairing mode, turn the N86 off and on again.
- Reorient or relocate the receiving antenna.
Check that the headphones are in pairing mode.
- Increase the separation between the equipment and receiver.
Ensure your device is within wireless range.
Reset your audio device and activate wireless.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Fail to nd
Ensure that your audio device is not already connected
to another wireless device.
N86
The microphone is embedded in the N86 for hands-free conversation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
First-time battery charge
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Let the N86 fully charged the rst time you charge it. When you're
ready to charge, turn off the headphones and plug them into a
powered USB port. The Indicator Light will turn red to indicate the
headphones are charging. When the Indicator Light turns off, the
headphones are fully charged. For a long-lasting battery, only charge
your headphones when the battery has fully run out.
SHORT
PRESS
LONG
PRESS
Works with included 3.5mm audio cable
Play/Pause/Phone call
Turn on/off
Next Track
AUX
Plug the AUX Cable into the N86 and connect the other end to your audio source
(e.g. laptop, MP3 player, tablet, etc.)
Volume up
WARNING
Adjust headphones sound to the proper volume. Loud sound may damage your ears.
For trafc safety, never use the headset while riding a bicycle, motor bike and driving a car.
Headphone Controls
Will AUX work after the battery runs out?
Yes, even if the N86 battery runs out, audio will still play through the AUX Cable.
Volume Down
Previous Track
Make sure the xxx fully charged when 1st time you charge it to the indicator light will turn red for charging and turns off for
fully charged.
DO recharge every 3 months in case constantly NO-USE, to keep the inside battery healthy.
Loading...
